Mini UVC germicidal lamp USB

Sun, 07 Jun 2026 05:53:03 +0800

Out on the plant floor, a microbe on a tool handle, a keyboard, or a component is a contamination risk that can stop a run cold. Wiping protocols drag out changeovers, and chemical residues linger where you don’t want them. So we built the Mini UVC Germicidal Lamp USB to hit those spots fast and leave zero residue behind. What you get under the hood It’s a low-pressure mercury vapor lamp in ozone-free quartz, tuned to 254nm for germicidal action. The quartz envelope is doped to block the 185nm line, so no ozone forms. Output is 15mW/cm² at 10mm, and it knocks out 99.9% of common microbes in under 30 seconds. The lamp runs off 5V USB, draws 2.5A, and sits in an industrial aluminum body with a fixed 30° beam angle for repeatable coverage. Rated life is 8,000 hours, with less than 10% output decay by 6,000 hours. Here’s why it makes sense in printing and finishing areas. Cross-contamination on shared controls, pallets, and squeegees can carry inks and pathogens from job to job. With a footprint this small, you can mount the lamp right on workstations, tool carts, and inspection stations. Ozone-free operation keeps operator breathing easy—no sharp smell, no need to over-ventilate. You get quicker changeovers, fewer rejects, and you cut consumable costs compared to constant wiping. The USB power makes it simple to integrate without dedicated fixtures. But—UVC is no joke. It’s hazardous to skin and eyes. Fit interlocks and clear safety signage, and never run it without proper shielding. Keep the supply stable at 5V. If the voltage dips, output drops and warm-up drags. For consistent dosing, stay in the 10–20mm working distance and keep the quartz surface clean; oils and dust scatter output and rob you of dose. Check reflector alignment so irradiance stays uniform across the target.

High output amalgam UVC lamp

Mon, 01 Jun 2026 23:54:37 +0800

On a garment line running 150+ prints per minute, the conveyor doesn’t pause for ink to “dry.” It needs instant cross-linking. Conventional drying turns into a bottleneck fast. The fix is a UV curing system built around a high-output amalgam UVC lamp. What actually matters, spec-wise We size these amalgam lamps by peak irradiance, not just wattage. Hitting 1200 mW/cm² at the substrate gives you the photon flux needed to break down the photoinitiator in UV-curable inks quickly. The spectrum stays tightly controlled, with primary peaks at 365nm and 385nm, so you get penetration into pigmented layers without surface quenching. The amalgam formulation holds output steady over 8,000 hours, with under 8% degradation, and the ozone-free quartz envelope keeps the workspace from getting grimy. Why this works on the floor In garment printing, curing in seconds is the difference between making rate and getting stopped. Our lamps cure UV inks in under 0.5 seconds, so the press keeps running at full speed—no inter-station drying delays. That means more units per day and less scrap from smearing. Energy use is tighter too: the high electrical-to-UV conversion efficiency knocks operating cost per print down by up to 25% compared with standard mercury lamps. What you need to plan for These lamps are built for specific curing units, so arc length has to match and the reflector alignment needs to be dead on. The system requires a dedicated power supply with a matched ballast, plus active lamp cooling to stay inside the operating temperature window. And plan on reflector upkeep—dust on the dichroic coating can drop spectral efficiency by 10% within a few months in dusty environments.

UVC on UV Curing Link

Mini UVC germicidal lamp USB

High output amalgam UVC lamp